3
Unpacking and inspection
This product has been thoroughly inspected and tested before shipment and is ready for operation.
After carefully unpacking, inspect for shipping damage before attempting to operate. If any indication of mechanical damage is
found contact immediate the responsible transport service and your local KROHNE representative.
A simple operating check of the electronics after unpacking and before permanent installation, is advisable to ascertain whether it
has suffered damage during shipment. Confirm for the correct mains voltage printed on the nameplate. If it differs from the
ordered product please contact your local KROHNE representative.
After connecting to the mains, check if there is any indication on the display and if the backlight of the display is lighted. If not
contact your local KROHNE representative for advise.
Disclamer
This document contains important information of the product. KROHNE attempts to be as accurate and up-to-date as possible but
assumes no responsibility for errors or omissions. Nor does KROHNE make any commitment to update the information contained
herin. This manual and all other documents are subject to change without notice. KROHNE will not be liable for any damage of
any kind by using its product, including, but not limited to direct, indirect, incidental, punitive and consequential damages. This
disclamer does not apply in case KROHNE has acted on purpose or with gross negligence. In the event any applicable law does
not allow such limitations on implied warranties or the exclusion of limitation of certain damages, you may, if such law applies to
you, not be subject to some or all of the above disclamer, exclusions or limitations. Any product purchased from KROHNE is
warranted in accordance with the relevant product documentation and our Terms and Conditions of Sale. KROHNE reserves the
right to alter the content of its documents, including this disclamer in any way, at any time, for any reason, without prior
notification, and will not be liable in any way for possible consequences of such changes.
CAUTION
There are no operator servicable parts or adjustments within the product enclosure
Refer all servicing to trained service technicians
Source power shall be removed from the product to perform any servicing
This product is prepared for the nominal AC mains voltage indicated on its tagplate. To reconfigure
the product power input for other mains voltages as listed in the chapter Technical data, the product
must be modified including the fuses by a trained service technician. After a power input
reconfiguration
the
tagplate needs to be adapted.
This product is a Class 1 device, (earthed which utilizes a proper connection to the protective earthing
for protection from electrical shock to ensure operator and its environmental safety.
The protective conductor terminal of the product shall be properly connected to the protective earth
wiring of the source power to ensure safety from electrically shock. See instruction manual
Protective
earthing
conductor
terminal.
This symbol indicates the point on the product to which the protective earthing conductor shall be
connected. It is positioned near the terminal block, inside the terminal compartmen. The diameter of
the protective earthing conductor shall be in accordance with the Low Voltage Directive.
Manufacturer
The GFM 700 is developed and manufactured by
KROHNE Altometer
Kerkeplaat 12
3313 LC Dordrecht, The Netherlands
Summary of Contents for GFM 700 F
