Klaus Krick Modelltechnik • Postfach 11 38 • D-75 434 Knittlingen
Telefon 0 70 43 / 9 35 10 • Telefax 0 70 43 / 3 18 38 • www.krick-modell.de
Victoria • Steam Launch 20261
Recommended accessories
1 x Set of equipment for Victoria, Order No. 20 263
3 x dietary iron shot, Order No. 60 112
Also, you still need a clutch shaft between the ship and steam engine.
1 x Articulated coupling 4 to 4 mm Order no. 63 704
1 x Double Joint Order no. 63 510
1 x Coupling unit individually Order no. 63 500
or
1x articulated coupling 4 to 5 mm Order no. 63 705
1x Double Joint Order no. 63 510
1x coupling unit individually Order no. 63 500
All parts are numbered for easy identification on the plan and listed in numerical order in the parts list. Carefully
follow instructions and always use glues and cements as specified.
All materials and accessories required, which are not supplied with the kit, are mentioned at the end of the parts
list.
We wish you lots of pleasure with your „Victoria“ and always a hand‘s breadth of water under her keel.
Technical data:
Scale:
1:10
Length:
1077 mm
Width:
253 mm
Height:
290 mm
Victoria Building Instructions
Before you remove any parts from the laser sheets, number them with pencil according to the reduced scale dra-
wings elsewhere in these instructions. Remove them as required later on and square off their edges with a sanding
block if not otherwise specified.
To make the cradle, which is essential for the assembly,
first cut parts 213, 214 and 215 from the 7 mm plywood
sheet, sand their edges carefully and then cement the parts
together. Let dry thoroughly, prime with sanding sealer and
finish off assembly with clear varnish or synthetic enamel.
Cut surplus material off hull 1 by scoring several times
along the line visible around the outer side with a pointed
modeling knife as shown in Figs. A and B. Then make one
vertical cut each at bow and stern through to the scored
lines and bend the surplusmaterial to and fro until it breaks
off eventually.
