KRESS 108 AS 1,3, Instructions Manual

Page: 28 / 224

28 English Tools and accessories
AkkuBS_CN-EN / 1004
EN
Fixing screws
Before screwing larger, long screws into hard ma-
terials, it is advisable to predrill a pilot hole with the
core diameter of the thread to approx. 2/3 of the
screw length.
Thread cutting
We recommend the use of machine thread taps.
Lightly oil the thread tap.
Select low speed and 1st gear.
Cut in clockwise direction, stop, remove in
anticlockwise direction.
5. Tools and accessories
When drilling metal, use only sharpened HSS drill
tips (HSS=High-Speed Steel) which are in perfect
condition.
Observe the notes in the illustrated instructions.
Devices with QuiXS holder (Option)
Fitting the QuiXS chuck (Accessories)
Pull the unlocking ring VII back.
Fit the QuiXS chuck I onto the drill spindle up
to the stop 1 and release the unlocking ring
VII .
Removing the QuiXS chuck
Pull the unlocking ring VII back and remove
the QuiXS chuck I .
Fitting the QuiXS angle adapter (Acces-
sories)
Remove the bit IX from the hexagon-shaped
socket 2 .
Fit the angle adapter XI onto the drill spindle
1 and twist it until it engages in the desired
position.
Lock the angle adapter XI in position by tight-
ening the unlocking ring VII .
Removing the QuiXS angle adapter
Loosen the unlocking ring VII as far as the
stop.
Take off the angle adapter XI .
Devices without QuiXS holder
On devices not equipped with a QuiXS holder,
have the chuck replaced by an authorised cus-
tomer service station.
The battery operated lamp generates a beam of
light.
Inserting the battery
Use only original KRESS batteries with the volt-
age shown on the rating plate of your lamp.
Use of any other batteries may lead to the risk of
injury or fire.
Insert the charged battery 5 into the handle
until you feel it click into place.
On/Off
To start up the battery lamp, press the On/Off
switch
XII .
To switch the battery lamp off, press the On/
Off switch
XII again.
Do not use accessories made by other manufac-
turers, as these are not tested by KRESS.
It can be dangerous to use such accessories.
To avoid injury and damage, use only accessories
recommended by KRESS.
-NOTE-
Always work at low speed when thread cutting.
This prevents the thread tap breaking off.
Changing the tool holding fixture
Remove the battery from the device
before undertaking any work on the
device.
This safety measure prevents acci-
dental starting of the power tool.
QuiXS quick change system
-NOTE-
The bit IX in the hexagon-shaped socket 2 can
remain in the drill spindle 1 while fitting the chuck.
-NOTE-
The angle adapter can be engaged in various
angle positions.
Battery lamp (Special accessories)
Special accessories