28
Connection Steps
Position the power supply and preamplifier where you intend to use them in your
system. Do not move the connected chassis after they are assembled.
The following steps describe how to connect an Phantom preamplifier to your
system:
1.
Connect the power supply chassis and preamplifier chassis with the 12-pin DC
cable provided, using the DC power connectors (24) on the back panels.
2.
Neatly arrange and organize wiring to and from the Phantom preamplifier and
all components. Separate AC wires from audio cables to prevent hum or other
unwanted noise from being introduced into the system.
3.
Connect the outputs of your source equipment to the appropriate CAST (18),
balanced (15), single-ended (16), or tape inputs (17) on the Phantom.
4.
Connect the appropriate main outputs (20) on the Phantom to your amplifier.
5.
Connect the supplied AC power cord to the IEC power cord receptacle (27).
6.
Plug the AC power cord into AC power. The front panel display (3) scrolls
through
PHANTOM SOFTWARE VERSION,
and the red stand-by LEDs illuminate (7),
indicating that the Phantom preamplifier is in stand-by mode. The scrolling
stops when the Phantom is ready to be powered on.
Note
Use only the power cord provided or Krell Vector HC power cable with the Phantom
preamplifier to make the connection to AC power. Operation with a power cord other
than the one supplied by Krell could induce noise, limit current, or otherwise impair the
ability of the preamplifier channel to perform optimally.
