Interval
Maintenance work
Personnel
annually or every 500
operating hours
Check groove ring for leaks, replace if neces-
sary (
Chapter 7.4 ‘Disassembling and
assembling gear box and compressed-air
motor’ on page 22
)
Qualified personnel
every 1000 operating
hours
Replace gear oil (
Qualified personnel
7.2 Cleaning
WARNING!
Danger of injury due to improper cleaning!
–
Adhere to the safety data sheets of the cleaning product manufacturer.
–
Do not use any halogenated cleaning products.
–
Ensure compatibility of the cleaning product with the agitator material.
NOTICE!
Material damage due to contamination!
Sticky residue on agitator impellers or agitator shaft can lead to imbalance or to blockages.
Residue accumulation on the drive parts can impact the heat dissipation.
–
Clean the entire agitator after each use.
1.
Disconnect the compressed-air supply.
2.
If necessary, vent container with the all stop-cock until the container is depressurised. See
operating manual of the compressed-air container.
WARNING!
Risk of injury due to heavy loads!
Depending on the agitator and container cover, the total weight can be significant.
–
If necessary, carry out lifting work with two people.
3.
Remove agitator with container cover. If applicable, refer to the operating manual of the
container or the lifting system.
4.
Clean agitator with suitable cleaning product.
Pneumatic agitator RL 72
ENGLISH
Article no.
■
200-0356
GB–21
Summary of Contents for 200-0356
Page 44: ......
