Krautzberger 200-0151, Operating Instructions Manual

Page: 24 / 44

7 Maintenance
Personnel:
n Qualified personnel
Protective equipment:
n Protective gloves
n Safety goggles
WARNING!
Risk of injury through the use of incorrect spare parts!
The use of incorrect or defective spare parts can cause risks for the personnel as well as
damage, malfunctions or complete failure.
– Only use original spare parts from Krautzberger or spare parts that have been approved
by Krautzberger.
– In case of questions, always contact our service department.
CAUTION!
Risk of injury through compressed air!
Uncontrolled leaks of compressed air can lead to serious injuries!
– Prior to any work on the device, all compressed-air lines must be closed and bleed if nec-
essary.
7.1 Maintenance schedule
The following sections describe the maintenance work that is required for optimal and fault-free
operation of the device. Check wearing parts such as seals, nozzles, and needles at regular inter-
vals. The level of wear depends on the abrasiveness of the spray fluid used. Escaping air and
spray fluid as well as the deterioration of the spray pattern are signs that parts are worn. In case of
questions about maintenance work and intervals, contact the manufacturer; see contact informa-
tion on the last page.
Interval Maintenance work Personnel
Before performing any
maintenance work Clean automatic spray gun (
Ä
Chapter 7.2
‘Cleaning spray guns’ on page 25 )
Qualified personnel
if needed Change fluid and air nozzle (
Ä
Chapter 7.3
‘Changing the air and fluid nozzles’ on page 26 )
Qualified personnel
Change fluid needle ( Ä Chapter 7.4 ‘Changing
the fluid needle’ on page 27 )
Qualified personnel
Change needle packing ( Ä Chapter 7.5
‘Changing needle packing’ on page 29 )
Qualified personnel
Operating instructions
T-Dok-144-GB-Rev.1
mail@krautzberger.com, www.krautzberger.com GB–24