7.2
Cleaning spray guns
WARNING!
Danger of injury due to improper cleaning!
–
Observe the safety data sheets of the cleaning product manufacturer.
–
Do not immerse the automatic spray gun entirely in cleaning product.
1.
Chapter 6.5 ‘Operation breaks’ on page 23
).
2.
Switch off the system and secure it against being switched on again.
3.
Connection cleaning product to fluid input.
For design with circulation connection (optional), connect the fluid circulation line.
4.
Switch on the compressed air supply.
5.
Begin the spray process by switching on the control air (connection "St") and the atomisa-
tion air (connection "Z").
6.
Spray until the cleaning product runs clear.
7.
Interrupt the cleaning product supply.
8.
Blow out cleaning product residue by briefly switching on the control air.
9.
Switch off the compressed air supply and secure it against restart.
10.
Clean the outside of the device with a cloth dipped in cleaning product.
11.
Chapter 7.3 ‘Changing the air and fluid nozzles’
) and clean with a soft brush. Do not use hard or sharp-edged objects. We rec-
ommend our brush set. See the last page for contact information.
12.
Lightly grease sliding parts with suitable grease (e.g. type no. 7026-120-0351 of the manu-
facturer, contact information see last page).
Automatic spray gun A-14
ENGLISH
■
200-0151
GB–25
