9
Step 9: Flush faucet
Flushing and checking for leaks:
After the
installation is complete, unscrew and remove
the spray head in order to flush the line. Turn
on the water supply and allow both hot and
cold water to run for at least one minute each.
This flushes away any debris that could cause
damage to internal parts. Check for leaks.
Re-attach the spray head. Do not lose the
gasket (1) in the hose.
Operating the sensor:
Turn the handle (2)
away from the faucet to the full on position.
Turn the water on by activating the sensor (3)
by waving your hand within 6cm of the sensor.
Move handle towards you and away from you,
the water flow pattern can be switched from
the hot water to cold water. If the sensor does
not work, then you can refer to the
troubleshooting. If you want to use the faucet
without the sensor feature, then you can refer
to troubleshooting 5. Then, turning on the
water can be done by moving the handle away
from the faucet to the full on position.
Cold
Hot
1
2
3
6cm MAX
Note: The sensor is active only when the
handle is in the ON position. As a water
saving feature, the water will turn off
automatically after 3 minutes of continuous
flow.
NOTE: Please make sure washer is installed
attaching spray head to hose.
