6
Manual
www.kraun.com
First, Connect the IP Camera to the home/office network
Please connect the IP Camera accessaries to the IP Camera body correctly, including the antenna, bracket,
power adapter and Ethernet cable, as shown in Figure 2-3. And connect the other end of the Ethernet cable
to the home network or office network. Usually, this Ethernet cable is plugged into a home NAT/router
device or an Ethernet switch if in the office, as shown in Figure 2-4. Since the default settings of the IP
Camera use DHCP function and very often there is a DHCP server on most of the Home/office network, the
IP Camera should be connected to the Internet immediately. The Internet status LED is constant red light
to indicate this good connection status. If the LED is blinking, please refer to section 3.3~3.5 to try other
network settings.
Figure 2-3: IP Camera connection diagram.
Figure 2-4: Connect Ethernet cable to a switch/router.
