4
Manual
www.kraun.com
2. HArdWAre deSCrIPTIon And QuICk
InSTAllATIon/uSAge
The IP Camera is designed to be very easy to install and use. First, let’s see the major components of the IP
Camera products.
2.1. Major hardware components.
The major components on the
front panel
of the IP Camera products are the built-in microphone, lens and
LEDs :
1. Microphone – for receiving the audio/voice. Effective distance is about 5 meters.
2. Lens – the focus of the lens is fixed, you do not need to spend time to adjust the focus, the effective
focus range is from 30cm to infinity.
3. Status indication LED (red) – this LED is to indicate the Internet connection status. When the Internet
connection is connected, the LED will be constant red light. If there is any Internet connection
problem, the LED will be blinking red light.
4. Ethernet indication LED (blue) – this LED is to indicate if the Ethernet link is ok and packet traffic is
sending/receiving. When the Ethernet cable is connected, the LED is constant blue light. When there
is packet sending/receiving, the LED is blinking blue light.
Figure 2-1: Major components in the front panel
The major components on the
back panel
of the IP Camera products are the bracket screw jack, power
jack, Ethernet jack and reset button:
1. Bracket screw jack – this is the position to screw in the bracket of the IP Camera. With the bracket, you
can put the IP Camera on the desk, on the wall or on the ceiling.
2. Power jack – this is the place to plug in the power adaptor. The power needed for this IP Camera is
5V/1.0A, please make sure you are using the correct power adaptor.
3. Ethernet jack – this is the place to plug in the RJ45 Ethernet cable. When the Ethernet link is ok, the
Ethernet indication LED on the front side will be blue light.
