Kraun KN.1D, User Manual

Page: 23 / 25

44 www.kraun.it
Manual Manual
www.kraun.it 45
Chapter 7. Appendix 3: FAQ
Q1: Microsoft ICS service is pending.
A1: If ICS service cannot be enabled after a long time, please re-switch from Sta-
tion Mode to AP Mode ,if not successful ,please restart the computer.
Q2: ICS is already bound by another network device.
A2: Microsoft ICS service can only combine one group of WAN and LAN. This
message indicates ICS may have been enabled by other network adapters.
Please manually cancel ICS and re-switch to AP mode.
Manually enable or cancel ISC.
Q3: Failed to enable ICS.
A3: Microsoft ICS service can only combine one group of WAN and LAN. This
message indicates ICS may have been enabled by other network adapters.
1. Please manually cancel or restart and cancel ICS, then re-switch to AP mode.
2. This dialogue box appears because virtual wi-fi miniport adapter can only be
used by one wireless network adapter at a time. Please disable any other non-
Kraun wireless network adapters and re-switch to AP mode.
Q4: Under Windows 7,when I switch from station mode to AP mode ,the screen
flashes“Disabling ICS, please wait……”and immediately return to station
screen.
A4: This is because you have disabled “Microsoft Virtual WiFi Miniport
Adapter”,please re-enable it and then switch to AP mode.
Q5: Client cannot obtain IP when connected to soft AP of the wireless network
adapter.
A5: Manually set an IP address at the same net segment as that of the AP and
the gateway and DNS at the IP address of AP.Thus, communication can be
achieved.
Q6: The SSID is not fully displayed on the wireless network list, what should I
do?
A6: Keep the mouse on the displayed SSID for about 2 seconds, as the below
picture shows,and you’ll see the full SSID on the appearing box.