30
www.kraun.it
Manual
Manual
www.kraun.it
31
In this mode, the wireless adapter acts as an AP to transmit wireless signal and cre-
ate a wireless network, while allowing other wireless clients to access this network.
As shown in the diagram below: The PC in the left has already accessed to the In-
ternet by using a wired network adapter, meanwhile, you install a Kraun wireless
adapter (take a USB wireless adapter as an example) and its UI on this computer,
and set the adapter to AP mode.
By using the wireless adapters to scan the AP’S SSID to connect, the computers in
the right can also access to the Internet after successfully connected
In this mode, the client utility differs from that in station mode, and the main inter-
face is as shown below.
When it is switched to AP mode, the wireless adapter will automatically set its IP
address as 192.168.123.1, and other clients that connected to this AP will automati-
cally obtain the IP addresses of: 192.168.123.X(X is any integer from 2 to 254).The
function buttons on the top (From L to R )are respectively Config AP, Advanced,
Access Control List, Associate List, About, Help, and MiniSize, while the left column
displays Turn On/Off RF, Security /No security, and AP mode icon.
4.2.1 Config AP
This screen is used to set the AP’s general parameters including SSID, wireless mode,
channel, authentication type and encryption type, as shown in the picture below.
Summary of Contents for KN.1D
Page 25: ...48 www kraun it Manual ...
