INSTRUKCJ
A MONTAŻU I OBSŁUGI –
SERIA LEO wersja 1.0
57
After lighting up the
control flame, a spark
appears on the electrode
Check the correct connection between the chopper and the
controller.
If the electronic amplifier is damaged, replace the receiver.
The control flame goes
out automatically
Check that the thermocouple sensor is functional and correctly
connected to the gas control module.
Check if the control flame is able to heat the thermocouple sensor.
Check that the gas control module gas valve is not damaged.
The main burner does
not ignite
Check that the main burner holes are not blocked.
Check the height of the control flame.
Check that the control flame is not obstructed by decorative
elements.
Check that the thermocouple sensor is functional and correctly
connected to the gas control module.
Check if the control flame is able to heat the thermocouple sensor.
The main burner goes
out automatically
Check the tightness of the air / flue gas system along its entire
length.
Check the routing of the exhaust air system.
Check if the end of the air / flue gas system is derived in
accordance with applicable regulations, taking into account any
difficulties related to wind pressure.
The main burner goes
out automatically when
the fireplace reaches a
certain temperature
Check thermostat settings.
Check that the automation components are not exposed to
temperatures:
-
higher than 55˚C (receiver with batteries);
-
higher than 80˚C (controller, receiver without batteries).
On the glass
sediment is deposited
Check that the main burner holes are not blocked.
Check that the gas pressure in the installation is correct.
Check that the correct nozzle is installed in the main burner.
Check the correctness of the exhaust gas system.
Check the patency of the chimney installation.
The device cannot be
turned off from the
remote control position
Shut off the gas supply.
If there is no response, replace the gas control module.
Check the correct connection between the chopper and the
controller.
