The LEO 100 inserts are equipped with a gas control system allowing the user to remotely lighten the
fireplace and to fully control the hearth. To enable operating the insert from the remote control:
• Make sure that the shut
-off valve installed on the gas supply to the fireplace is open.
• If the system is equipped with a cable with a
switch, set it to „I” (on). The main valve knob is switched
automatically.
NOTE!!!
Never use tools to change the position of knobs. Changing the position of the knobs can only be made
by hand, otherwise you may damage the controller. In the case of locking the knobs, contact your
service representative.
The LEO uses modern B6R-H9 remote controls set in accordance with standard for radio frequency
868MHz. The remote control supplied with the fireplace requires a new code transmission. To do it, in
the
first place, press and hold the „RESET“ button on the receiver until you hear two characteristic
signals and then release the button. This operation should be done by means of the thin element with
blunt ends. Further on, from the remote control, press and hold , until you hear two short beeps,
indicating the remote control is synchronized with the receiver. One long beep indicates that the
elements of the system have not been properly paired.
Figure. RESET button
–
receiver
INFORMATION
To view the current version of the software used by the remote control, simultaneously press the
and . Simultaneous pressing the button and the button will display the remote control model.
Deactivating the remote control.
Install batteries. All available icons will appear on the display and will flash. During the flashing, press
the appropriate icon for the function and hold it for 10 seconds. The icon appropriate for the selected
button will flash until the end of the deactivation process. The remote control display shows the icon
adequate for the selected function and two horizontal lines. If the function is deactivated two
horizontal lines will appear on the display when pressing the button responsible for its selection. After
replacing batteries, the settings will remain unchanged.
Activating the remote control.
Install batteries. All available icons will appear on the display and will flash. Press the appropriate icon
for the function and hold it for 10 seconds. The icon appropriate for the selected button will flash until
the end of the activation process. The remote control display shows the icon adequate for the selected
function.
Summary of Contents for LEO/100
Page 6: ...DIMENSIONS...
Page 7: ......
Page 8: ...Figure 1 Leo series dimmensions...
