Kratki LEO/100, Manual Instruction

Page: 15 / 63

• Bottom flashing doors
• Flashing doors gasket
• Air inlet
All the above parts might be replaced with if necessary. If your appliance requires any part
replacement, please contact your supplier or Manufacturer.
WARNING: you cannot use any substitutes as it will affect on warranty loss and may cause some
serious problems with your appliance operation.
In case of chamber glass replacement, you may use the glass certified with the appliance and
reccomended by the manufacturer in this instruction and using the holding bars and gaskets
provided by your authorized dealer or manufacturer only.
The LEO series has been designed for your safety and comfort. This series has the ability to remotely
control the operation of the fireplace by a remote control. The air supply to the combustion chamber
and flue gases exhaust are achieved by the use of a coaxial chimney system. The LEO series is equipped
with special means to prevent any uncontrolled outflow of gas from the system.
SAFETY
Carefully read the following information:
• Connecting a fireplace to a gas installation and its maintenance can be carried out only by a
qualified fitter or a service technician of heating gas appliances. 46
• If the control flame goes out, wait for at least five minutes before trying again.
• It is strictly forbidden to make any modifications in the design of the fireplace.
• Gas control system components must not be exposed to moisture.
• Do not operate the unit without inserting its glass.
• Do not touch hot parts of the fireplace, in particular, the glass.
• While children or other unaware persons are near a working unit they should not remain
unattended.
• It is forbidden to place decorative elements used for the lining of the combustion chamber in
front of the control flame.
• Do not place flammable materials near the fireplace.
• It is prohibited to place combustible materials in the combustion chamber. If you feel gas
leakage, do not operate the unit. As soon as possible, shut off the gas, ventilate the room where the
fireplace is and contact your service representative.
• Any cracked glass should be immediately replaced.
• In the case of malfunctioning, cut off the gas supply and contact your service representative.
INSTALLATION INTRODUCTION
The fireplace is equipped with protective devices against uncontrolled outflow of gas from the main
burner. Before connecting the appliance, please read all connection diagrams given in this chapter.
The gas insert is adapted to be connected to a special coaxial chimney system allowing simultaneous
supply of fire into the air and flue gas discharge to the outside of the building. To ensure proper
operation, installation of the fireplace can only be done by qualified persons with appropriate licences.