Inspections
The guarantee period is 12 months according to VDMA.
The guarantee is void if changes are made to the safety devices or if the machine is used
at excess temperatures or speeds. The guarantee is also void if the machine is used
with a voltage below the required rating, with less than the required amount of water, with
dirty water and
external
damage to the pressure gauge, nozzle, high pressure hose and
spray device.
This guarantee is not applicable for spare parts.
Our operating instructions must be complied with.
Guarantee
The machine is designed for accidents to be impossible if used correctly.
The operator is to be notified of the risk of injury from hot machine parts and the high
pressure water jet. The “Guidelines for Liquid Spray Devices” must be complied with.
(see page 14 and 15)
Check the oil level at the oil dip stick prior to each use.
(Ensure horizontal position!)
Oil change:
The oil of your high pressure pump should be changed after approx. 40 hours of operation, or
no later than when it takes an a grey o whitish colour. To change the oil, remove the two
combination screws on the base-plate at the bottom, take off the base-plate and pull out the oil
drainage hose. Put the hose over a container and take off the closure cap. Put the pump in
the horizontal position to drain off all the oil. The oil must be caught in a container and dis-
posed of in a responsible,
legal manner.
OIl quatity:1.0 l
Oil typ:
W 15-50 SAE
semi-synthetic oil
Accident prevention
The machine must be inspected according to the “Guidelines for Liquid Spray Devices”
at least once every 12 months by a qualified person, to ensure that continued safe
operation is guarateed.
The results of the inspection are to be recorded in writing.
This may be done in any form.
Water
1
2
3
4 5
6
7
8
9
10
11
6 High pressure injector for cleaning
agents (not with K 3170 TST)
7 High pressure hose
8 Spray gun
9 Interchangeable lance with turbokiller
10 Interch. lance with regulator nozzle
11 Pressure regulation
1 Water inlet connection with filter
2 Suction hose with filter
(Special accessory No. 15.038 3)
3 High pressure pump
4 Pressure gauge with glycerin filling
5 Unloader valve - safety valve
220 V
The
KRÄNZLE 2170 TST + 3200 TST + 3250 TST + 3270 TST -
high pressure cleaners are mobile machines. The design can be seen from the dia-
gram.
Construction
Item
Description
Description
Description
Description
Description
General rules
General rules
General rules
General rules
General rules
42
3
