Description
Description
Description
Description
Description
38
7
Brief operating instructions
When operating your high pressure cleaner pay attention that
it is in a horizontal position.
1.
Connect the high pressure hose with spray gun and machine.
2.
Connect to suitable water supply
.
3.
Flush the air from the pump (open and close the spray gun several times)
4.
Make the electrical connection
- (220 Volt
three-phase current
).
5.
Switch on the machine and commence cleaning.
6.
After completing the work, completely empty the pump (switch the motor on for
approximately 20 seconds without the suction and pressure hoses).
Only use clean water ! Protect from frost !
CAUTION !
Please pay attention to the regulations of your waterworks company. In accordance with
DIN 1988, the machine may not be directly connected to the public drinking water supply
lines.
A brief connection however is permissible according to DVGW (German Association for
Gas and Water Affairs) if a tube ventilator with check valve (Kränzle Order-No. 410 164) is
built into the water supply.
Also indirect connection to the public drinking water supply lines is permissible by way of
free emission in accordance with DIN 1988, part 4; e.g. by using a reservoir with a float
valve.
Direct connection to a non-drinking water supply line is permissible.
High pressure hose and spray device
The high pressure hose and spraying device supplied with the machine are made of high
grade material, they are also optimized for the machine and marked as required by the appro-
priate regulations.
If replacement parts are required, only such parts that are authorized by the
manufacturer and which bear the markings required by the appropriate regula-
tions may be used. The high pressure hose and spray device must be con-
nected in a pressure-tight manner. The high pressure hose may not be driven
over, pulled excessively, or twisted. The hose may under no circumstances be
pulled over sharp edges, since otherwise the guarantee is automatically void.
Wiring diagram
Wiring diagram
Wiring diagram
Wiring diagram
Wiring diagram
On-Off switch
Inlet line via
CEE 3 x 2,5mm²
220 V / 60 Hz
Motor
230 V / 60 Hz
Pressure switch
Control plate with
T
rafo 230 V / 50/60 Hz
overload
protection
23-32 Ampere
