Using the WP-210E XGA Line Driver
7
5.2 Operating the WP-210E XGA Line Driver
To operate your
WP-210E
XGA Line Driver
:
1. Connect your XGA source (for example, a laptop’s graphics card) to the
XGA Input HD15F connector.
2. Connect the HD15F Loop connector to a local monitor, if required
1
.
3. Push in the ID Bit button to set to ON.
4. Adjust
2
the output signal level and/or cable compensation equalization
level, if required.
1 Push in the TERM switch if the loop output is used, otherwise make sure that the TERM switch is released
2 Use a screwdriver to carefully rotate the Potentiometer, adjusting the appropriate level
