#
Feature
Function
17
PROG/RS-485 TERM
DIP Switches
PROG
DIP switch enables microcontroller firmware upgrade.
RS-485 TERM
DIP switch terminates the RS-
485 line with a 120Ω load.
18
RS-485
Terminal Block Port
Connect to a RS-485 control device (see Step 4).
19
ETHERNET
RJ-45 Connector
Connects to a PC or other serial controller through computer networking LAN.
20
MACH #
DIP Switches
Use the set the Machine number of the unit (see Step 4).
21
ETH RESET
Button
Press to reset to factory default definitions:
IP number
−
192.168.1.39, Mask
– 255.255.0.0, Gateway – 0.0.0.0
22
OUTPUT
BNC Connectors
Connect to the serial digital video acceptors.
23
REMOTE IR
3.5mm Mini Jack
Connect to an external IR receiver unit for controlling the machine via an IR remote control
(instead of using the front panel IR receiver).
24 Power Connector with Fuse
Connect to the electricity mains using the power cord.
25 Power Switch
Turns the power to the unit ON and OFF.
Step 3: Mount VS-88HDxl
To rack mount the machine, attach both rack ears
(by removing the screws from each side of the
machine and replacing those screws through the
rack ears) or place the machine on a table.
•
Ensure that the environment (e.g., maximum ambient temperature &
air flow) is compatible for the device.
•
Avoid uneven mechanical loading.
•
Appropriate consideration of equipment nameplate ratings should be
used for avoiding overloading of the circuits.
•
Reliable earthing of rack-mounted equipment should be maintained.
Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your
VS-88HDxl
.
RS-232 Connection:
Use a 9-wire straight cable and connect only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5 to the RS-232 9-pin D-sub port on
your PC.
Note:
A null-modem adapter/connection is not required.
RS 485 Connection:
You can operate the
VS-88HDxl
via the RS-485 port from a distance of up to 1200m (3900ft).
To connect a control device with a RS-485 port to the
VS-88HDxl
:
1. Set the
VS-88HDxl
RS-485 machine number and bus termination.
2. Connect the A (+) pin, B (
–) pin, and G pin on the RS 485 port of the PC to the corresponding pins on the RS 485 port
on the rear panel of the
VS-88HDxl
. Note: Pin G may be connected to the shield, if required.