VS-88HDxl
Quick Start
P/N: 2 9 0 0 - 3 0 1 2 5 6 QS
Rev: 2
Scan for full manual
VS-88HDxl Quick Start Guide
This guide helps you install and use your
VS-88HDxl
for the first time.
www.kramerav.com/downloads/VS-88HDxl
to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check
what’s in the box
VS-88HDxl
8x8 3G SD/HD-SDI Matrix Switcher
1 Set of rack ears
4 Rubber feet
RC-IR3
IR remote control transmitter
1 Power cord
1 Quick start guide
Step 2: Get to know your VS-88HDxl
#
Feature
Function
1
IR Receiver
Receives signals from the IR remote control transmitter. Lights yellow when receiving
signals.
2
POWER
LED
Lights when the unit is ON.
3
ALL
Button
Press
ALL
and then press an
IN
button to connect the selected input to all outputs.
4
OFF
Button
Press
OFF + OUT
to disconnect the selected output from the inputs.
Press
OFF + ALL
to disconnect all outputs.
Press and hold OFF to toggle between dual link and normal mode.
5
IN SELECT
Buttons
Press to select the input to switch to the output.
Press and hold buttons IN1 to IN5 to change the genlock timing (see Step 4)
6
OUT SELECT
Buttons
Press to select the output to which the input is switched.
7
STO
(STORE) Button
Press
STO
and then press an
IN/OUT
SELECT
key to store the current setting.
8
RCL
(
RECALL
) Button
Press
RCL
and the relevant
IN/OUT SELECT
key to recall a setup from the non-volatile
memory.
9
LOCK
Button
Press and hold for three seconds to disable/enable the front panel buttons.
10
TAKE
Button
Press to confirm a command in Confirm mode (see Step 6).
11 7-segment
INPUT
Display
Displays each input under the output number that it is switched to.
12
GENLOCK
BNC Connector
Connect to the genlock source.
13
TERM HI-
Z/75Ω
Pushbutton
Press to terminate the
genlock source (75Ω) or release for looping.
14
LOOP
BNC Connector
Connect to the genlock connector of the next unit in the line.
15
INPUT
BNC Connectors
Connect to the serial digital video sources.
16
RS-232
9-pin D-sub (F) Port
Connect to a PC or a control device.
