Caution:
•
For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
•
Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
•
To ensure continuous risk protection, replace fuses only according to the rating specified on the product label which located on the bottom of the unit.
Step 6: Operate the VS-88H2
Web pages:
RS-232 and Ethernet:
RS-232/Ethernet
Baud Rate:
115,200
Parity:
None
Data Bits:
8
Command Format:
ASCII Protocol
3000
Stop Bits:
1
Example (Route input 1 to output 1):
#VID1> 1<cr>
Ethernet Parameters
IP Address:
192.168.1.39
Default TCP Port #:
5000
Subnet Mask:
255.255.0.0
Default UDP Port #:
50000
Default Gateway: 192.168.0.1
Full Factory Reset
Front panel:
Front panel buttons: power off the device, press and hold the
LOCK, EDID and STO buttons simultaneously for 3 seconds
while powering the device, and then release.
Protocol 3000:
“#factory” command.
Web Pages:
In the Device Settings page, click Reset.
Front panel buttons:
The 7-segment display shows the status of
VS-88H2
during normal operation and displays device information.
Generally, to switch an input to an output, select the switching mode and then:
•
Press an output button and then an input button.
•
Press
ALL
to route a selected input to all outputs.
To set the switching mode:
•
Press
VIDEO
to switch the video signal of a selected input to the selected output.
•
Press
D-AUDIO
(HDMI embedded audio signal) to switch the digital audio signal of a selected input to the selected
output.
•
Press
VIDEO
+
D-AUDIO
simultaneously to switch the video and digital audio signals of a selected input to the
selected output.
•
Press
MUTE/PATTERN
to switch the pattern signal to the selected output. Use the input buttons to select which
pattern you want to display. (Each input button is associated with a unique pattern).
•
Press
ARC
, an input button, and then an output
button. The selected output port sources its ARC to the selected input
port ARC.
7-segment display example
When in Video mode, the 7-segment display shows the input-output status:
In this example: Input 1 is routed to output 1, input 3 is routed to output 2, input 2 is routed to outputs 3 and 7, a patter n is
routed to output 4, output 5 is set to mute, and so on.