Step 5: Connect the power
Connect the 5V DC power adapter to the
VS-411UHD
and plug it into the mains electricity.
Safety Instructions
Caution:
There are no operator serviceable parts inside the unit.
Warning:
Use only the Kramer Electronics power supply that is provided with the unit.
Warning:
Disconnect the power and unplug the unit from the wall before installing.
See
for updated safety information.
Step 6: Set the DIP-switches
Set the Mode/Preset DIP-switches as shown Set the Audio Select DIP-switches
in the following table:
as shown in the lower table:
DIP
Function
Off (Up)
On (Down)
1
Audio EDID
Pass audio EDID of sink
Limit to 2-CH LPCM
2
Color EDID
Pass deep color parameter of sink
Limit to RGB 8bpp
3
Lock EDID
Pass EDID of sink
Lock current display EDID and the current
settings of DIPs 1 and 2 (The settings of DIPs 1
and 2 cannot be changed when DIP 3 is locked)
This state also allows copying the default EDID
or an EDID file to the inputs. (If using EDID
Designer, refresh after copying)
4
HDCP
Enable HDCP support
When Off, if the output supports HDCP, the input
declares HDCP support. It then handles HDCP on
the output and input actively. If the output does not
support HDCP then the input does not support
HDCP
Disable HDCP support
When On, the device does not support HDCP on
its input, even if HDCP is detected on the output
5
ARC or Step-in for the 1st
HDMI input
Step-in
ARC audio
6
Analog Output Audio From
Source
ARC audio
7
Output Off
Disable (to support audio only embedding)
Enable
8
Output Off Delay Settings
15sec default (configurable)
15min
Audio Select DIP-switches
DIP #
Function
Description
Off (Up)
On (Down)
1
Input 1 audio embedding
Embed analog audio only if the HDMI video does
not have audio (DVI)
Always embed analog audio
2
Input 2 audio embedding
3
Input 3 audio embedding
4
Input 4 audio embedding
