Kramer Protocol 2000
KRAMER: SIMPLE CREATIVE TECHNOLOGY
16
7 Kramer Protocol 2000
The
VS-311H
is compatible with Kramer’s Protocol 2000
1
Table 6: Protocol Definitions
(version 0.46)
(below). This RS-232/RS-485 communication protocol uses four bytes of
information as defined below. For RS-232, a null-modem connection between
the machine and controller is used. The default data rate is 9600 baud, with
no parity, 8 data bits and 1 stop bit.
MSB
LSB
DESTI-
NATION
INSTRUCTION
0
D
N5
N4
N3
N2
N1
N0
7
6
5
4
3
2
1
0
1st byte
INPUT
1
6
I5
I4
I3
I2
I1
I0
7
6
5
4
3
2
1
0
2nd byte
OUTPUT
1
O6
O5
O4
O3
O2
O1
O0
7
6
5
4
3
2
1
0
3rd byte
MACHINE NUMBER
1
OVR
X
M4
M3
M2
M1
M0
7
6
5
4
3
2
1
0
4th byte
1
st
BYTE:
Bit 7 – Defined as 0
D – “DESTINATION”:
0 - for sending information to the switchers (from the PC);
1 - for sending to the PC (from the switcher)
N5
N0 – “INSTRUCTION”
The function that is to be performed by the switcher(s) is defined by the INSTRUCTION (6 bits) Similarly, if a function is
performed via the machine’s keyboard, then these bits are set with the INSTRUCTION NO , which was performed The
instruction codes are defined according to the table below (INSTRUCTION NO is the value to be set for N5
N0)
2
nd
BYTE:
Bit 7 – Defined as 1
I6
I0 – “INPUT”
When switching (ie instruction codes 1 and 2), the INPUT (7 bits) is set as the input number which is to be switched
Similarly, if switching is done via the machine’s front-panel, then these bits are set with the INPUT NUMBER which was
switched For other operations, these bits are defined according to the table
3
rd
BYTE:
Bit 7 – Defined as 1
O6
O0 – “OUTPUT”
When switching (ie instruction codes 1 and 2), the OUTPUT (7 bits) is set as the output number which is to be switched
Similarly, if switching is done via the machine’s front-panel, then these bits are set with the OUTPUT NUMBER which was
switched For other operations, these bits are defined according to the table
4
th
BYTE:
Bit 7 – Defined as 1
Bit 5 – Don’t care
OVR – Machine number override
M4
M0 – MACHINE NUMBER
Used to address machines in a system via their machine numbers
1 You can download our user-friendly “Software for Calculating Hex Codes for Protocol 2000” from our Web site:
http://www kramerelectronics com
When several machines are controlled from a single serial
port, they are usually configured together with each machine having an individual machine number If the OVR bit is set, then
all machine numbers will accept (implement) the command, and the addressed machine will reply
