VS-21DPIR - Connecting the VS-21DPIR
7
4.1
Using the Remote Control Transmitter
You can use the remote control transmitter to switch INPUT 1 or 2 to the output.
Before doing so, set it to work with the
VS-21DPIR
by assigning a GROUP
number.
The setup parameters for the remote control transmitter are as follows: router number = 1
(default); group number = 11, single digit mode (default), video (default). For further details,
see the RC-IR2 user manual.
To assign the GROUP number on the remote control transmitter, do the following:
1. Point the remote control transmitter at the remote receiver (item 6 in
Figure 1
) and press the GROUP key.
2. Press key 11.
This sets and saves the group number.
To switch INPUT 1 or 2 to the output via the remote control transmitter, press key
1 or 2.
4.2
Controlling via the REMOTE Terminal Block Connector
The contact closure remote control pins operate in a similar way to the output
SELECT button. Using the contact closure remote control lets you select an output
by remote control. To do so, temporarily connect the required input (OUT1 or
OUT2) pin on the REMOTE terminal block connector to the G (ground) pin, as
illustrated in the examples in
Figure 3
.
Caution: DO NOT
connect more than one PIN to the G PIN
at the same time
To select OUT 1, attach PIN OUT1 to the
G PIN:
To select OUT 2, attach PIN OUT2 to the
G PIN:
Figure 3: Connecting the REMOTE Input Select Connector
!
