Step 5: Connect power
Connect the power cord to
VS-211UHD
and plug it into the mains electricity.
Safety Instructions (See
for updated safety information)
Caution:
•
For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
Step 6: Set DIP-switches
Set the DIP-switches as shown in the following table:
DIP
Function
Off (Up)
On (Down)
1
Audio EDID
Pass audio EDID of sink
Limit to 2-CH LPCM
2
Color EDID
Pass deep color parameter of sink
Limit to RGB 8bpp
3
Lock EDID
Pass EDID of sink
Lock current display EDID and the current settings of
DIPs 1 and 2 (The settings of DIPs 1 and 2 cannot be
changed when DIP 3 is locked)
This state also allows copying the default EDID or an
EDID file to the inputs when using EDID Designer. (If
using EDID Designer, refresh after copying)
4
HDCP
Enable HDCP support
When On, if the output supports HDCP,
the input declares HDCP support. It
then handles HDCP on the output and
input actively. If the output does not
support HDCP then the input does not
support HDCP.
Disable HDCP support
When Off, the device does not support HDCP on its
input, even if HDCP is detected on the output.
5
Auto Embedding
Port 1
Embed analog audio only if the video is
DVI
Always embed analog audio input
6
Auto Embedding
Port 2
7
Audio From
Source
ARC
8
Output Off Delay
Settings
15sec default (configurable)
15min
