34
VP-772 - Controlling the VP-772
8.2
Controlling via the OSD Menu
You can change Preview/PiP Window parameters, Program/Main window
parameters and entire system parameters via the OSD menu, as described in
Section
6
.
8.2.1
Connecting to the VP-772 via RS-232
You can connect to the
VP-772
via an RS-232 connection using, for example, a
PC. To connect the RS-232 terminal block on the rear panel of the
VP-772
to
a
PC/controller connect the RS-232 9-pin D-sub port on your device to controller as
shown in
Figure 15
, connect
the
VP-772
RS-232 terminal block:
TX pin to Pin 2
RX pin to Pin 3
GND pin to Pin 5
Figure 15: RS-232 Connection
8.2.2
Connecting the VP-772 via the ETHERNET Port
You can connect to the
VP-772
via Ethernet using either of the following methods:
Directly to the PC using a crossover cable (see
Section
8.2.2.1
)
Via a network hub, switch, or router, using a straight-through cable (see
Section
8.2.2.2
)
Note
: If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.