KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using Your VP-6AHD 1:6 UXGA / Audio / +1 CAT5 Distributor
8
6 Using Your VP-6AHD 1:6 UXGA / Audio / +1 CAT5 Distributor
The example in Figure 3 illustrates how to output a computer graphics signal
(and audio) from a computer to up to six local monitors, as well as how to
transmit it over UTP cabling to a
TP-122
XGA / Audio Line Receiver
.
To connect the
VP-6AHD
and a
TP-122
, do the following:
1. Connect a computer graphics source (for example, a computer) to the
UXGA INPUT 15-pin HD connector and to the UNBAL. AUDIO IN
3.5mm mini jack, for example, using a Kramer C-GMA/GMA cable
1
.
Press the IN SELECT button
2
.
2. Connect the UXGA OUTPUT 15-pin HD connectors to up to
3
six
acceptors (for example, Local Display 1 to Local Display 6).
3. Connect up to
3
12 stereo audio outputs
4
, that is, up to six:
Unbalanced stereo audio OUT 3.5mm mini jacks,
and
Balanced
5
stereo audio 5-pin terminal block connectors (see section 6.1)
4. Connect
6
the CAT 5
RJ-45 LINE OUT connector
7
to the
LINE IN RJ-45
connector on a Kramer CAT 5 receiver, such as the
TP-122
unit.
5. Connect the power cord
8
to the
VP-6AHD
(not illustrated in Figure 3).
6. On the
VP-6AHD
:
Adjust
9
the UXGA cable compensation equalization level and/or the
audio level, if required
Set the ID BIT switches 4 and 11 on the underside to ON (by sliding
them to the left). This would enable a notebook or laptop (if connected
instead of a computer) to output an UXGA signal to an external VGA
monitor
1 XGA 15-pin HD(M) +Audio jack to XGA 15-pin HD(M) +Audio jack (not supplied). The complete list of Kramer cables is
on our Web site at http://www.kramerelectronics.com. Alternatively, you can connect an XGA source to the XGA INPUT 15-
pin HD connector, and a separate audio source to the UNBAL. AUDIO IN
2 Alternatively, connect a computer graphics source to the INPUT 15-pin HD connector, and a balanced stereo audio source to
the BAL. AUDIO INPUT 5-pin terminal block connector, and release the IN SELECT button
3 When not all outputs are required, connect only the outputs that are required and leave the other outputs unconnected
4 Note, that if the selected audio input is unbalanced, it is converted to balanced stereo audio; if the selected audio input is
balanced, it is converted to unbalanced stereo audio
5 By wiring the balanced outputs as unbalanced (see Figure 5) you can output 12 unbalanced stereo audio outputs
6 Via UTP cabling, with a range of more than 300ft (>100m): see section 6.1
7 The TP-122 (or TP-120) may be powered via this connector (instead of via the 12V DC external supply)
8 We recommend that you use only the power cord that is supplied with this machine
9 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
