Step 3: Mount VP-558
To rack mount the machine, attach both
rack ears (by removing the screws from
each side of the machine and replacing
those screws through the rack ears) or
place the machine on a table.
•
Ensure that the environment (e.g., maximum ambient
temperature & air flow) is compatible for the device.
•
Avoid uneven mechanical loading.
•
Appropriate consideration of equipment nameplate ratings
should be used for avoiding overloading of the circuits.
•
Reliable earthing of rack-mounted equipment should be
maintained.
Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your
VP-558
.
Balanced stereo
audio connection:
Unbalanced stereo
audio output
connection:
Balanced Stereo
Audio Input
Connection
Unbalanced Stereo
Audio Input
Connection
Wiring the RJ-45 Connectors
To achieve specified extension
distances, use the recommended
Kramer cables available at
www.kramerav.com/product/VP-
558
Using third-party cables may cause
damage!
This section defines the TP pinout,
using a straight pin-to-pin cable with
RJ-45 connectors.
EIA /TIA 568B
PIN
Wire Color
1
Orange / White
2
Orange
3
Green / White
For HDBT cables, it is recommended
that the cable ground shielding be
connected/soldered to the connector
shield.
4
Blue
5
Blue / White
6
Green
7
Brown / White
8
Brown
Step 5: Connect power
Connect the power cord to
VP-558
and plug it into the mains electricity.
Safety Instructions (See www.kramerav.com for updated safety information)
Caution:
•
For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
•
Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
•
To ensure continuous risk protection, replace fuses only according to the rating specified on the product label which located on the bottom of the unit
•
Suitable for installation in Information Technology Rooms in accordance with Article 645 of the National Electrical Code and NFPA 75.
Peut être installé dans des salles de matériel de traitement de l’information conformément à l’article 645 du National Electrical Code et à la NFPA 75.
