Your VGA/XGA Audio Matrix Switcher
5
4.1 Connecting the VP-4x4
To connect the
VP-4x4
, connect the following
1
to the rear panel ports:
Power cord
VGA / XGA video input and output cables
Audio input and output cables
A PC via the null-modem adapter (when using the Kramer Control
software or other controller) if control via RS-232 is required
RS-485 Phoenix terminal block cable if control via RS-485 is required
In addition, set the dipswitches as section 4.1.3 describes.
4.1.1
Connecting a PC
To connect a PC to the
VP-4x4
, without using a Null-modem adapter:
Connect the RS-232 DB9 port on your PC to the RS-232 DB9 rear panel
port on the Master
VP-4x4
unit, as Figure 2 illustrates (depending on whether
the PC has a 9-pin or 25-pin connector)
Figure 2: Connecting a PC without using a Null-modem Adapter
To connect a PC to the
VP-4x4
, using a Null-modem adapter:
Connect the RS-232 DB9 rear panel port on the Master
VP-4x4
unit
to
the
Null-modem adapter and connect the
Null-modem adapter with a 9 wire
flat cable to the RS-232 DB9 port on your PC, as Figure 3 illustrates
1 Switch OFF the power on each device before connecting it to your VP-4x4. After connecting your VP-4x4, switch on its
power and then switch on the power on each device
