#
Feature
Function
14 AUDIO IN 3.5mm Mini Jack
Connects to an unbalanced stereo audio source.
15 DATA (G, Rx, Tx)Terminal Block
Connectors
Connect to a source for tunneling control commands via HDBaseT.
16 CTRL (G, Rx, Tx)Terminal Block
Connectors
Connect to the PC or the remote controller to control
VP-428H2
.
17 ETHERNET RJ-45 Connector
Connect to a PC via a LAN to tunnel Ethernet data via HDBT.
18 HDBT
OUT RJ-45 Connector
Connect to an HDBaseT receiver.
19 48V DC Power Terminal Block
Connector
Connect to the Kramer power adapter.
Step 3: Install the VP-428H2
Install
VP-428H2
using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to
www.kramerav.com/downloads/VP-428H2
•
Mount the unit in a rack using an optional
RK-T2B
rack adapter.
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your
VP-428H2
. For best results, we recommend that you
always use Kramer high-performance cables to connect AV equipment to the
VP-428H2
.
Step 5: Connect the power
Connect the 48V DC power adapter to the
VP-428H2
and plug the adapter into the mains.
Safety Instructions
Caution:
There are no operator serviceable parts inside the unit.
Warning:
Use only the Kramer Electronics power supply that is provided with the unit.
Warning:
Disconnect the power and unplug the unit from the wall before installing.
See
for updated safety information.
