Kramer Electronics Ltd.
VP-427X1
– Operating and Controlling VP-427X1
18
Viewing Device Information
Device information includes the selected source, the input and output resolutions, and the
software version.
To view the information:
1. On the front panel press
MENU
. The menu appears.
2. Click
INFO
and view the input resolution, output resolution and software version.
Information is displayed.
Performing a Reset
VP-427X1
enables performing either a soft reset or a full reset via the front panel MENU
buttons.
To reset the device:
1. On the front panel press
MENU
. The menu appears.
2. Click
Factory
and select either Reset (full reset) or a Soft Reset (reset device
information excluding Ethernet parameters), then click
Yes
.
Wait for completion of factory reset (resolution is set to Native).
Device is reset.
Operating via Ethernet
You can connect to
VP-427X1
via Ethernet using either of the following methods:
•
Directly to the PC using a crossover cable (see
Connecting Ethernet Port Directly to a
•
Via a network hub, switch, or router, using a straight-through cable (see
Ethernet Port via a Network Hub
).
Note
: If you want to connect via a router and your IT system is based on IPv6, speak to your
IT department for specific installation instructions.
Connecting Ethernet Port Directly to a PC
You can connect the Ethernet port of
VP-427X1
directly to the Ethernet port on your PC using
a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying
VP-427X1
with the factory configured default IP address.
After connecting
VP-427X1
to the Ethernet port, configure your PC as follows:
1. Click
Start
>
Control Panel
>
Network and Sharing Center
.
2. Click
Change Adapter Settings
.