Connecting and Configuring the VP-16x18AK
13
13
6
Connecting and Configuring the VP-16x18AK
This section describes how to:
Connect the
VP-16x18AK
Connect a balanced stereo audio output (see
Connect the
VP-16x18AK
to a remote control device via:
Set the RS-485 termination and machine number (see
6.1
Connecting the VP-16x18AK
Always switch off the power on each device before connecting it to your
VP-16x18AK
. After connecting your
VP-16x18AK
, connect its power
and then switch on the power on each device.
To connect
1
the
VP-16x18AK, as illustrated in the example
2
1. Connect the VGA (up to UXGA) sources (for example, computer
graphics sources) to the 15-pin HD VIDEO INPUT connectors.
2. Connect the unbalanced stereo audio sources (for example, the audio
source of the computer) to the 3.5mm mini AUDIO INPUT jacks.
3. Connect the 15-pin HD VGA VIDEO OUTPUT connectors to the
video acceptors (for example, video displays).
4. Connect the AUDIO OUTPUT terminal block connectors to the
balanced stereo audio acceptors (for example, balanced stereo audio
amplifiers with speakers).
5. If required, you can connect a PC and/or controller to the:
6. Connect the power cord
3
).
1 You do not need to connect all inputs and outputs
2 Switch off the power on each device before connecting it to your VP-16x18AK. After connecting your VP-16x18AK,
switch on its power and then switch on the power on each device. Do NOT push in the rear panel PROG button, it is reserved
for service use
3 We recommend that you use only the power cord that is supplied with this machine
i