KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting and Configuring the VP-16x18AK
16
6.5 Connecting to the VP-16x18AK via the Ethernet Port
You can connect the
VP-16x18AK
via Ethernet using either of the
following methods:
Direct connection to the PC using a crossover cable (see
Connection via a network hub, switch or router using a
straight-through cable (see
Note:
The following instructions are valid only if your PC uses a fixed IP
address. If your PC receives an IP address from a DHCP server, consult
your IT department regarding a suitable IP address.
6.5.1 Connecting Directly to the Ethernet Port
You can connect the Ethernet port of the
VP-16x18AK
to the Ethernet port
on your PC via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identification of the factory
default IP Address of the
VP-16x18AK
during the initial configuration
To connect the VP-16x18AK directly to a PC using a crossover cable:
1. Using a crossover cable, connect the
VP-16x18AK
to the PC via the
Ethernet port on both units.
2. On the PC, click
Start
>
Control Panel.
3. Double-click
Network Connections.
4. Right-click, and from the menu select
Properties
.
The
Local Area Connection Properties
window appears.
5. Select
Internet Protocol (TCP/IP)
).
