Connecting the VP-111K UXGA Line Driver
5
5
Connecting the VP-111K UXGA Line Driver
To connect the
VP-111K
, as the example in
Figure 2
illustrates, do the
following
1
:
1. Connect a computer graphics source (for example, a laptop) to the INPUT
15-pin HD (F) connector.
2. Connect the OUTPUT 15-pin HD (F) connector to an acceptor (for
example, a projector).
3. Connect the LOOP 15-pin HD (F) connector to an acceptor (for
example, a local display).
4. Connect the 5V DC power adapter to the 5V DC socket and connect the
transformer to the mains electricity (not illustrated in
Figure 2
).
5. Set the termination switch as follows:
If no acceptor is attached to the LOOP connector, press the
pushbutton in to the 75 setting
If a acceptor is attached to the LOOP connector, set the
pushbutton out to HI-Z setting
1 Switch OFF the power on each device before connecting it to your
VP-111K
. After connecting your
VP-111K
, switch on
its power and then switch on the power on each device
