KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the Distributors
16
5.5
Connecting the VM-50YC 1:5 s-Video Distributor
To connect the
VM-50YC
, as shown in
Figure 10
, do the following
1
1. Connect the input video source (for example, an s-video player) to the
INPUT IN s-video connector.
:
2. If looping the input to another device, connect a video acceptor (for example
an s-video monitor) to the INPUT LOOP s-video connector.
3. If the input loop is not used, press IN the
TERM pushbutton to add a 75Ω
termination to the line. If an input loop is used, release the TERM
pushbutton.
4. Connect the OUTPUTS 1 to 5 s-video connectors to up to 5 acceptors
2
5. Connect the 12V DC power supply to the unit (not shown in the illustration)
and then to the mains electricity. Switch on the power.
(for
example, s-video recorders).
Figure 10: Connecting the VM-50YC 1:5 s-Video Distributor
1 Switch OFF the power on each device before connecting it to your VM-50YC. After connecting, switch on the VM-50YC
power and then switch on the power on each device
2 You are not required to connect all the acceptors
Summary of Contents for VM-2N
Page 6: ...Getting Started 3 3 ...
