KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the Distributors
12
5.1
Connecting the VM-2N Video Audio Distributor
To connect the
VM-2N
, as shown in
Figure 6
, do the following
1
1. Connect the input video source (for example, a composite video player) to
the VIDEO IN BNC connector.
:
2. Connect the input audio source (for example, the audio from a composite
video player) to the AUDIO IN RCA connectors noting the right and left
channels.
3. Connect the VIDEO OUT 1 and 2 BNC connectors to up to 2 acceptors
2
4. Connect the AUDIO OUT 1 and 2 RCA connectors to up to 2 acceptors
(for example, composite video recorders).
2
(for example, the audio input on the composite video recorders).
5. Connect the power cord
3
6. If needed, adjust the LEVEL ands EQ controls on the underside of the unit
(see
to the unit (not shown in the illustration) and then
to the mains electricity. Switch on the power.
Figure 1
).
Figure 6: Connecting the VM-2N Video Audio Distributor
1 Switch OFF the power on each device before connecting it to your VM-2N. After connecting, switch on the VM-2N power
and then switch on the power on each device
2 You are not required to connect two acceptors
3 Use the power cord supplied with the unit
Summary of Contents for VM-2N
Page 6: ...Getting Started 3 3 ...
