KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the Distributors
14
5.3
Connecting the VM-50HN Headphone Distributor
To connect the
VM-50HN
, as shown in
Figure 8
, do the following
1
1. Connect the input audio source (for example, a stereo audio player) to the
INPUT 6.5mm phone connector.
:
2. Connect the OUT 1 to OUT 5 6.5mm phone connectors to up to 5
acceptors
2
3. Set the MONO pushbutton OUT for stereo operation and press IN for mono
operation (see
(for example, stereo headphones or speakers).
Figure 3
).
4. Connect the 12V DC power supply to the unit (not shown in the illustration)
and then to the mains electricity. Switch on the power.
5. Adjust the volume for each output using a small screwdriver to turn the
potentiometers on the front panel (see
Figure 3
).
Figure 8: Connecting the VM-50HN Headphone Distributor
1 Switch OFF the power on each device before connecting it to your VM-50HN. After connecting, switch on the VM-50HN
power and then switch on the power on each device
2 You are not required to connect all the acceptors
Summary of Contents for VM-2N
Page 6: ...Getting Started 3 3 ...
