Kramer TP-873xr, User Manual

Page: 6 / 14

Kramer Electronics Ltd.
TP-873XR / TP-874XR
– Defining TP-873XR HDMI 4K Line Transmitter
4
Defining TP-873XR HDMI 4K Line
Transmitter
TP-873XR HDMI 4K Line Transmitter
This section defines TP-873XR .
Figure 1: TP-873XR HDMI 4K Line Transmitter
# Feature Function
IN LED Lights green when an active source device input signal is
detected.
OUT LED Lights green when an active, far-end sink (acceptor) output signal
is detected via the DGKAT link.
ON LED Lights green when the device receives power.
HDMI
™ IN Connector
Connect to an HDMI source.
DGKAT-2 OUT RJ-45 Connector Connect to the DGKAT-2 IN RJ-45 connector on the TP-874XR .
SETUP DIP-switches Set the operation DIP-switches (see Setting the DIP-Switches
on page 9 ).
IR 3.5mm Mini Jack Connector Connect to an external infrared emitter / sensor for IR signal
bidirectional extension to control a remote device. For example,
connect to an external infrared sensor to control the HDMI OUT
acceptor that is connected to
TP-874XR .
RS-232 (G, Rx, Tx) 3-pin
Terminal Block Connector Connect to an RS-232 port for serial signal bidirectional extension
to the receiver. For example, connect to an
SL-240C controller
device to serially control the HDMI OUT acceptor that is
connected to
TP-874XR .
For firmware upgrade via the RS-232 port, contact Kramer Tech
Support.
12V DC Power Connector 12V DC connector for powering the unit when it is not powered by
TP-874XR via the DGKAT link.
1
2
3
4
5
6
7
8
9