TP-600TRxr
Quick Start
P/N: 2 9 0 0 - 3 0 1 4 9 9 QS
Rev: 1
Scan for full manual
TP-600TRxr Quick Start Guide
This guide helps you install and use your
TP-600TRxr
for the first time.
www.kramerav.com/downloads/TP-600TRxr
to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check
what’s in the box
TP-600TRxr
4K60 HDMI/USB Extender
1 Set of rack ears
4 Rubber feet
1 Power adapter and cord
1 Bracket set
1 Quick start guide
Step 2: Get to know your TP-600TRxr
The extender device functions as a transmitter or a receiver side per DIP-switch setting (see
#
Feature
Function
1
HOST USB B 2.0 Connector
Connect to the USB host (for example, a laptop) to communicate with the USB
peripheral devices (for example, a smart board) connected to USB device ports on
either the transmitter or the receiver sides of the extender (see
).
2
ACTIVE HOST LED
Lights orange when the USB host side is active
3
ACTIVE Rx LED
Lights green when the extender receiver function is active
4
IN LED
Lights blue when an active HDMI input signal is detected on HDMI IN.
5
OUT LED
Lights blue when an output acceptor device is connected.
6
TX LOOP
Transmitter mode Lights blue an active signal is transmitted on the Tx LOOP
port.
Receiver mode
N/A
7
LINK LED
Lights green when the HDBT active link connection is established.
8
ON LED
Lights green when the device receives power.
9
HDBT RJ-45 Connector
Connect to the HDBT RJ-45 connector on a paired receiver/transmitter device (for
example, a second
TP-600TRxr
device).
10
HDMI TX IN Connector
Transmitter mode Connect to an HDMI source.
Receiver Mode
N/A
11
HDMI Rx OUT/Tx LOOP
Connector
Transmitter mode Connect to a local acceptor.
Receiver mode
Connect to an HDMI acceptor.
12
USB A 2.0 Fast-Charging Connectors
(3)
Connect to the USB local peripheral devices (for example, a USB camera, a
soundbar, microphone and so on).
13
IR 3.5mm Mini Jack Connector
Connect to an external IR emitter to control a local IR-controlled device from the
remote extender (for example,
TP-600TRxr
).
Connect to an IR sensor to control a remote IR-controlled device connected to the
remote extender side (for example,
TP-600TRxr
).
14
RS-232 3-pin Terminal Block
Connect to a controller device (for example,
SL240C
) to control a remote device via
serial connection (for example, the remotely connected PTZ USB camera).
15
ETHERNET
RJ-45 Connector
Connect to LAN.
16
SETUP 4-way DIP-switch
Step 4:Connect inputs and outputs
17
12V DC Power Connector
Connect to the power supply.
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
