TP-590T
,
TP-590R
Quick Start
P/N: 2 9 0 0 - 3 0 1 4 2 4 QS
Rev: 1
Scan for full manual
TP-590T and TP-590R Quick Start Guide
This guide helps you install and use your
TP-590T
and
TP-590R
for the first time.
www.kramerav.com/downloads/TP-590T
and/or
www.kramerav.com/downloads/TP-590R
download the latest user manual and check if firmware upgrades are available.
Step 1: Check
what’s in the box
TP-590T
4K HDMI/USB Transmitter
OR
TP-590R
4K HDMI/USB Receiver
1 Bracket set
1 Power cord
4 Rubber feet
1 Quick start guide
Step 2: Get to know your TP-590T and TP-590R
TP-590T
#
Feature
Function
1
HOST USB 2.0 Connector
Connect to the USB host, (for example, a laptop) to communicate with the USB
peripheral devices (for example, a smart board) connected to USB device ports on
either the transmitter or the receiver.
2
ACTIVE HOST LED
Lights orange when the device is enabled as an active USB host (see
).
3
IN LED
Lights blue when an active HDMI input signal is detected on HDMI IN.
4
OUT LED
Lights blue when an output device is connected to the receiver.
5
LINK LED
Lights green when the HDBT active link connection is established.
6
ON LED
Lights green when the device receives power.
7
HDBT OUT RJ-45 Connector
Connect to the HDBT IN RJ-45 connector on the receiver.
8
HDMI IN Connector
Connect to the HDMI source.
9
USB 2.0 Charging Connectors (3)
Connect to the USB local peripheral devices (for example, a mic, a keyboard, a
mouse and so on).
10
RS-232 3-pin Terminal Block
Connect to a controller device (for example,
RC-306
) to control a remote device via
serial connection (for example, the PTZ USB camera that is connected to the
receiver).
11
IR 3.5mm Mini Jack Connector
Connect to an external IR emitter to control a local IR-controlled device from the
receiver side (for example,
TP-590R
).
Connect to an IR sensor to control a remote IR-controlled device connected to the
receiver side (for example,
TP-590R
).
12
SETUP 4-way DIP-switch
Sets the device behavior (see
13
5V DC Power Connector
Connect to the power supply.
