Kramer TP-590T Quick Start Manual Download Page 3

Page: 3 / 4

Step 4: Connect inputs and outputs

Always switch OFF the power on each device before connecting it to your

TP-590T

and

TP-590R

Wiring the RJ-45 Connectors

This section defines the TP pinout, using a straight pin-to-pin cable with
RJ-45 connectors.

EIA /TIA 568B

PIN

Wire Color

Orange / White

For HDBT cables, it is recommended that the cable ground
shielding be connected/soldered to the connector shield.

Orange

Green / White

Blue

Blue / White

To achieve specified extension distances, use the recommended
Kramer cables available at

and/or

Using third-party cables may cause damage!

Green

Brown / White

Brown

Summary of Contents for TP-590T

Page 1: ...ED Lights blue when an active HDMI input signal is detected on HDMI IN 4 OUT LED Lights blue when an output device is connected to the receiver 5 LINK LED Lights green when the HDBT active link connec...

Page 2: ...ntrolled device from the transmitter side for example TP 590T Connect to an IR sensor to control a remote IR controlled device connected to the transmitter side for example TP 590T 25 SETUP 4 way DIP...

Page 3: ...ectors EIA TIA 568B PIN Wire Color 1 Orange White For HDBT cables it is recommended that the cable ground shielding be connected soldered to the connector shield 2 Orange 3 Green White 4 Blue 5 Blue W...

Page 4: ...port is connected to an IR emitter cable 3 N A For future use 4 Programing RS 232 Off up FW programming RS 232 is inactive Normal operation mode is enabled On down FW programming RS 232 is active Step...