KRAMER: SIMPLE CREATIVE TECHNOLOGY
Setting the DIP-switches on the VP-14xl
6
4. Set the Hardware/Software DIP-switch (see
Section 6.4
) as follows:
In Hardware mode, set the REPLY DIP-switches to determine the unique
reply output port (see
Section 6.2
)
In Software mode, set the machine number (see
Section 6.2
).
5. Set the serial port baud rate (see
Section 6.3
).
6. Select the appropriate machine number (see
Section 6.2
).
7. Connect the 5V DC power adapter to the 5V DC socket and to the mains
electricity.
Note
: Changing any DIP-switch requires that you either power cycle
the
VP-14xl
or press the Reset button (see
Table 1
).
6
Setting the DIP-switches on the VP-14xl
Moving a DIP-switch down turns the switch on, moving it up turns the switch off.
Figure 3: VP-14xl DIP-switches
Table 2: VP-14xl DIP-switch Functions
DIP-switch #
Function
1
RS-485 termination
2, 3, 4
In Hardware mode: Sets the reply source
In Software mode: Sets the machine number
5, 6, 7
Sets the serial port baud rate
8
Sets Software/Hardware mode
6.1 Setting the RS-485 Bus Termination
DIP-switch 1 sets the RS-485 bus termination. Only the first and last physical
device on the RS-485 bus must be terminated, all other devices must be un-
terminated.
When the DIP-switch is:
•
OFF, the unit is un-terminated (default)
•
ON, the unit is terminated
