Installing the TBUS-4 Table Connection Bus
7
Figure 4: Cutout Dimensions
4. Unscrew and remove the template from the surface of the table and clean the
table surface.
Take care not to damage the table.
If needed, you can download a full-scale template from our Web site
1
.
Kramer Electronics is not responsible for any damage caused to the table
5.2 Adjusting the Height of the Connecting Surface
If needed, you can adjust the connecting surface to one of four possible
heights to accommodate large or bulky cables. By default, the height is set to
the second level from the top. To adjust, perform the following:
1. Remove the ten height adjustment screws (three screws on the front and back,
two screws on each side, as shown in
Figure 2
), while supporting the surface
from underneath with your fingers.
2. Raise or lower the connecting surface to the required height, insert the
screws, and tighten them in place.
1 At http://www.kramerelectronics.com