KRAMER: SIMPLE CREATIVE TECHNOLOGY
Installing the TBUS-4 Table Connection Bus
6
Table 2: TBUS-4 Connecting Surface Features
#
Feature
Function
1
Power Socket 1
Power socket for PC1
2
Ethernet connector 1
RJ-45 (female / female)
3
USB connector 1
USB-A (female / female)
4
Audio connector 1
3.5 mm stereo audio (female / female)
5
PC connector 1
Computer graphics 15 pin HD (female / female)
6
Power Socket 2
Power socket for PC2
7
Ethernet connector 2
RJ-45 (female / female)
8
USB connector 2
USB-A (female / female)
9
Audio connector 2
3.5 mm stereo audio (female / female)
10 PC connector 2
Computer graphics 15 pin HD (female / female)
5 Installing the TBUS-4 Table Connection Bus
To install
TBUS-4
, perform the following steps:
1. Cut an opening in the table (see section 5.1).
2. Adjust the height of the connecting surface (see section 5.2).
3. Install optional insert (see section 5.3).
4. Install
TBUS-4
in the cut-out opening (see section 5.4).
5. Connect the cables (see section 5.5).
5.1 Cutting an Opening in the Table
To cut an opening in the table:
1. Place the included cut-out template on the surface of the table where you want
to install
TBUS-4
.
2. Attach the template to the table with the included screws.
3. Following the inside edge of the template, cut a hole in the table surface with a
sabre or keyhole saw according to the dimensions shown in
Figure 4
(not to
scale).
Note
: The thickness of the table should be 3 inches or less.
