Connecting the TBUS-1
7
To install a wall plate or connector module, do the following:
1. Unscrew the two
screws attaching the
blank plate to the
Connecting Surface
and remove the
blank plate.
2. Place the required
wall plate item over
the opening, insert
the two screws to fix
the wall plate in
place, and tighten
them.
5.3 Adjusting the Height of the Connecting Surface
You can adjust the level of the Connecting Surface to one of four possible
heights. By default, the height is set to the second level from the top. If you
need to adjust the height
1
to fit your needs, do the following:
1. Remove the six height adjustment screws (two screws on each side and one
screw on the front panel and one on the rear panel, as shown in Figure 2),
while supporting the surface from underneath with your fingers.
2. Use your fingers to bring the Connecting Surface to the required height,
screw and tighten it in place using the height adjustment screws.
1 Bring the Connecting Surface closer to the table top or lower it, giving space for bulky devices or cables