Kramer MV-6, User Manual

Page: 14 / 75

10 MV-6 - Connecting the MV-6
5 Connecting the MV-6
Always switch off the power to each device before connecting it to your
MV-6 . After connecting your MV-6 , connect its power and then switch
on the power to each device.
The MV-6 accepts up to six SD/HD/3G HD-SDI inputs. The device outputs a
signal (which can be any combination of the inputs) to the SDI, HDMI and
composite video connectors as shown in Figure 3 .
To connect the MV-6 3G HD-SDI Multiviewer as shown in Figure 3 :
1. Connect up to six SDI sources (SD, HD or 3G HD-SDI) to the INPUT
BNC connectors (for example, 3G HD-SDI cameras to IN 1 and IN 3, and
an SDI player to IN 2).
2. Connect up to six SDI acceptors (SD, HD or 3G HD-SDI) to the INPUT
LOOP BNC connectors (for example, a preview SDI display to IN 1
—
LOOP and a non-linear editor to IN 2
—LOOP).
3. Connect up to three display acceptors to the OUTPUT connectors (for
example, a 3G HD-SDI display to the OUTPUT SDI BNC connector, an
LCD display to the HDMI connector, and a CV video recorder to the
OUTPUT CV BNC connector).
4. Optional
—Connect a PC and/or serial controller to the:

Ethernet connector (see Section
‎5.2
)
—and/or—

RS-232 port (see Section
‎5.1
)
5. Connect the power cord (not shown in the illustration).
i