Mounting the K-Able Box
9
9
To mount a single K-Able Box vertically as illustrated in the example in
1. Position the vertical-mounting bracket (see
) such that the
cable exits in line with the TBUS insert.
Note:
The vertical mounting bracket is designed to be mounted with the
extension against the side of the TBUS providing the correct spacing between
the TBUS and the
K-Able Box
.
2. Secure the vertical mounting bracket perpendicular to the TBUS on the
underneath of the table using at least four of the small screws supplied.
3. Slide the pin through the top mounting hole of the
K-Able Box
housing so that it protrudes the same distance from each side of the
hole.
4. Slide the bolt through the top rear mounting hole of the
K-Able Box
.
5. Screw the nut onto the bolt only until the end of the bolt is flush with
the nut.
6. Slide the pin at the front of the
K-Able Box
housing into the front of
the vertical mounting bracket at the same time as hooking the bolt onto
the rear of the vertical mounting bracket (see
).
Figure 7: Inserting the Pin and Bolt into the Bracket
7. Tighten the nut on the bolt, securing the
K-Able Box
to the vertical
mounting bracket.
8. Feed the cable through the
TBUS WCP
/
WCP-2
/
WCP-21
insert and
secure it to the plate of the TBUS.
9. Slide the plastic friction bush around the cable and press it into the
opening in the insert.
