Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your
FC-404NETxl
.
To achieve specified extension distances, use the recommended Kramer cables available at
www.kramerav.com/product/FC-404NETxl
Using third-party cables may cause damage!
Step 5: Connect power
If powering via PoE is not available, connect the power adapter to the
FC-404NETxl
and plug the power adapter into the
mains power supply.
Safety Instructions (See
for updated safety information)
Caution:
•
For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
Step 6: Operate FC-404NETxl
Operate
FC-404NETxl
via:
•
Remotely, by RS-232 serial
commands transmitted by a
touch screen system, PC, or
other serial controller
•
Embedded web pages via the
Ethernet
RS-232 Control / Protocol 3000
Baud Rate:
115,200
Parity:
None
Data Bits:
8
Command Format:
ASCII
Stop Bits:
1
Example (Set Dante, channel 2 audio level input to 10):
#x-aud-lvl
in.dante.1.audio.2,10
Default Ethernet Parameters (DHCP, by Default)
IP Address:
192.168.1.39
UDP Port #:
50000
Subnet mask:
255.255.255.0
TCP Port #:
5000
Gateway:
192.168.0.1
Device name:
FC-404Net-{ID} where ID = the last 4 characters of the
device’s serial number
Default Dante Parameters (Static, by Default)
Fall-back IP Address: 169.254.112.120
Subnet mask:
255.255.0.0
Gateway:
0.0.0.0
