Kramer F-121UK, User Manual, Page: 9 / 17

F-121UK - Installing the F-121UK 7
7
5 Installing the F-121UK
To install the F-121UK you have to install the inserts and the transmitter which is
connected via TP to a receiver.
To install the F-121UK , do the following:
•
Install the Kramer inserts (see Section 5.1
•
Connect the cables to the rear side (see
)
Section 5.2
•
Install the F-121UK inside the Ackermann floor box (see
)
Section 5.3
•
Connect the front panel ports (see
)
Section 5.4
•
Connect the twisted pair cable to the receiver (for example, the Kramer
TP-122N )
)
5.1 Installing a Kramer Insert
To install a Kramer insert, do the following:
1. Unscrew the two screws holding the blank insert and remove it.
2. Place and align the required wall plate insert item over the opening.
3. Insert the two screws to fix the insert in place, and tighten them.
5.2 Connecting the Cables to the Rear Side of the F-121UK
To connect the rear side cables, do the following:
1. Run the cables through the Ackermann underfloor cable opening.
2. Connect the cables to the rear side of the inserts.
3. Connect the cables to the rear side of the F-121UK transmitter, that is,
attach the:

Terminal block line output of the F-121UK to the pre-installed STP/UTP
wiring that connects to the TP receiver (for example, the Kramer
TP-122N with a range of more than 300ft (>100m)), see Section 5.5