Cobra MX-88 8x8 Matrix Switcher Operation
3
4.2 Input to Output Assignment
To assign an input channel (source) to an output channel (destination), press
the desired input key on the top row, and the desired output key(s) on the
bottom row of the selection keypad. If any outputs are assigned to the
selected input channel, the keys will be illuminated. When all assignments
have been made, press the ENTER key to update the matrix, or press the
CANCEL key to start again.
Multiple output channels may be assigned to a single input channel, but only
one input channel may be assigned to each output channel. To turn an output
channel off, press only the output key, then the ENTER key.
Pressing an input or output key will “toggle” the selection. It is not necessary
to press the CANCEL key to remove only the selected key from the current
assignment.
Pressing an input key will illuminate the input key and all outputs assigned to
this input. To re-assign the outputs to a new input, press the input key again,
then press the new input key. Press the ENTER key to update the matrix, or
press the CANCEL key to start again.
To turn an output channel off, make sure no inputs are selected, then press
only the output key, and the ENTER key.
4.3 Preset Command
To save the current matrix configuration, press the PRESET key, then the
input key that corresponds to the preset you wish to overwrite (1 – 8). Press
the ENTER key to save or the CANCEL key to start again.
4.4 Recall Command
To recall a saved preset configuration, press the RECALL key, then the input
key that corresponds to the preset you wish to recall (1 – 8). Press the ENTER
key to load the preset configuration or the CANCEL key to start again.
4.5 All Off Command
To turn all outputs off simultaneously, hold the CANCEL key for
approximately five seconds.
